L2 problem

Ama32

hi I had a problem with L2 the self check stops until number 25 and when I press L2 it doesn't work and also when I try to access any game it does no let me pass the start menu

Ama32

I noticed that the L2 button remained pressed indefinitely, that's why it does no let me pass the start menu

Soulja

I have the same problem L2 and R2 dont work. Just stays pressed. I have ensured the cable is installed correctly more than once. I dont know what is wrong. All other buttons work fine. Using BDM-030 kit with 030 controller.

Soulja

After getting a replacement FT6-V3 cable and new black ribbon cable that connects the main Besavior unit to the controller board, my controller is working now. L2 and R2 are fine and adaptive triggers also work. I do not know what fixed it exactly unfortunately. I would recommend re-seating cables, blow onto gold contacts for the ribbon cables to ensure proper connections/no dust. I am using BDM-030 with the latest PS5 controller firmware and Besavior firmware. I use it on PC and it works fine and I assume it will work fine on PS5 too. There is definitely some problems with this kit though, I don't know if I can recommend it. Was a lot of stress to get this working and I am experienced with modding like this. There is very little information on the kit, if something goes wrong you have to find a solution on your own.

Do.it

Ama32 replied at 2023-09-04 00:36
I noticed that the L2 button remained pressed indefinitely, that's why it does no let me pass the st ...

Just update firmware from the base firware. Im using latest 2023.07.04. Also, if you just installed the kit, just make sure that the stubs are inserted all the way in and even, then fully assemble the gamepad and just let it boot up. Triggers and stick may glitch at first. After a few hours the buttons magically start working properly. Don't forget to reser to factory settings after the update.